Images
The BoardPusher Skateboard Designer currently accepts images in JPEG and PNG
formats. Transparent PNG images are supported.
Don't put anything important right on the edge of the board in the Skateboard
Designer (e.g. If you want your name in small print on the very
bottom of the deck, it could get cut off if you don't leave some room on the
edge). The board size in the Skateboard Designer is approximate and the graphic can
shift slightly in printing.
If you want a graphic to print to the edge of the deck make sure to extend
it a bit over the edge in the Skateboard Designer to give it a bleed for printing
. Again, the board size in the Skateboard Designer is approximate and the graphic
can shift slightly in printing. If you upload a full bleed image to cover the
whole deck, the Skateboard Designer will
automatically give it the correct bleed.
Avoid enlarging a photo or other Jpeg graphic to be larger than it's original
size in your graphics program. This can cause the final graphic on
your deck to print out pixelated or blurry.
Deck Templates
If you want to upload full bleed designs, you can use the templates below to know exact size and truck placement for each deck shape. Minimum resolution allowed is 150 DPI, suggested resolution is 300 DPI. To download a template, right click on a link and select "Save Target As".
Designer Keyboard Shortcuts
- ←Move Left
- ↑Move Up
- →Move Right
- ↓Move Down
- +Enlarge
- -Shrink
- [Rotate CCW
- ]Rotate CCW